Outlook: When I send an email message it doesn't leave my outbox

Outlook: When I send an email message it doesn't leave my outbox

I ran into this problem today and was baffled until I found this link:

http://office.microsoft.com/en-ca/outlook-help/when-i-send-an-e-mail-message-it-doesn-t-leave-my-outbox-HA001187988.aspx
The above link says that it describes Outlook 2003, but the information applies to my Outlook 2010.

The symptoms are that in Outlook 2010, when I send a message, it goes to the outbox but is not in italics and does not get sent.
I can forward that same message and the copy goes just fine. Also, this is a global problem on several Outlook profiles, not just one.

The culprit turns out to be an Outlook Addin from Apple. I apparently had installed the application called iCloud on my laptop, and ever since then this problem existed.

I was able to simply disable this Addin and the problem was resolved.

Comments

"Blinky" TDOA RDF Detector

Our local Amateur Radio club is building a Radio Direction Finding TDOA (Time Difference of Arrival) detector that has LED's to indicate the direction (Left or right) of the fox. Here are the build instructions. (Note: this project was originally presented by NZ1J. See his video: https://www.youtube.com/watch?v=mNqUKYkifOo&t=68s ) Here is the completed project: We start with the schematic: Note that you either install PIN Diode pairs s D3 and D2, or Diodes pair D1 and D4. The difference between these is the packaging. If you are ok with Surface mount, then install D1/D4. If you want discrete components use D3/D2. Next is the PCB. The PCB can be ordered using the GRBR files available from the author. The BOM for the electronic parts is as such: Doppler Direction Finder Bill of Materials 11/12/2021 Qty Part Digi-key Part Numbe...

Radio Direction Finding - TDOA

This article describes a few projects that I built from plans for Amateur Radio Fox Hunting. Basically, the hobby/sport is for someone to hide a few low power "Foxes", which are small transmitters that beep or send Morse Code, and then have a bunch of HAM's try to find them. The first project that I built was a Yagi Antenna (Directional receiver) and a 4MHZ Offset Attenuator. The attenuator is needed when you get close to the fox and you need to reduce the power of the received signal. I struggled with this setup because, on my first 2 fox hunts, there was too much reflection and multi-path interference. This causes false direction detection and if you are not mentally prepared for this, you want to throw all of your equipment into a garbage can and take up a different hobby. There are some truly strange individuals who find this frustration fun and enjoy making other people suffer, but I will leave that discussion for another day. Anyw...

Wireless device monitoring with wavemon

Wireless device monitoring with wavemon wavemon is a wireless device monitoring software that allows you to watch signal and noise levels, packet statistics, device configuration, and network parameters of your wireless network hardware. It was written by Jan Morgenstern and is regularly maintained. It allows you to display your WiFi signal strength in realtime. Installation and start You install wavemon with sudo apt install wavemon -y And start it with wavemon and a dashboard appears. If you can’t see the function keys at the bottom, you need to make your Terminal window larger. What the information means Let’s quickly run through the data points that you want to look at to understand better the WiFi quality that your digital picture frame enjoys. Signal strength Basically, the higher the signal strength, the more reliable the connection and higher speeds are possible. The signal strength is specified as -dBm (decibels related to one ...

Pat Spencer

Search This Blog